Waterproofing membrane HYPERFLEX – P10
SBS improved bitumen elastic waterproofing membrane secured with synthetic polyester.
1m x 4mm x 10m/roll
|Field Of Application||
Basement, Roof, Toilet
Modern – Egypt
BITUM SBS REFRIGERATION NETWORK REFORMED BY SYNTHETIC TOOL
What is HYPERFLEX?
Manufactured by Modern waterproofing company, HYPERFLEX – P10 is the highest quality modified polymer bitumen waterproof membrane.
HYPERFLEX – P10 is denatured by SBS, thus assuring high flexibility under very low temperature conditions.
HYPERFLEX – P10 reinforced with synthetic polyester (P) of fiberglass-coated nonwoven polyester offers high mechanical properties and dimensional stability.
HYPERFLEX – P10 is a high performance film that can be applied virtually anywhere modified bitumen membranes applied under a hot burst method requiring high mechanical stress and is specified. low temperature variation,
HYPERFLEX – P10 can be used in:
Low temperature single layer roofing system
– Foundations and underground structures may fluctuate
– Waterproofing toilets, wet areas inside buildings
HYPERFLEX – P10 requires a full mineral coating on exposed (unprotected) roofing for inaccessible roofs or those with low traffic volume.
HYPERFLEX – P10 is designed with the special purpose of providing customers with a perfect and versatile product.
Advantages of HYPERFLEX – P10:
– Easy to apply (hot heat)
– High mechanical strength
– High resilience at extremely low temperatures down to -10 ° C
Chemical resistance may exist in the soil
Excellent high temperature performance
– Perfect adhesion on any surface
– High dimensional stability
– Environmental friendliness
Modern waterproof company ISO 9001. adopt strict quality control system using in-house laboratory. Samples are routinely analyzed by independent laboratories to ensure continuous compliance to the highest standards (ASTM, DIN, UNI, etc.)
Each HYPERFLEX – P10 roll is individually coded with a label containing all the necessary information about the roll. This is to ensure operability under ISO control standards.
Standard thickness available includes 3mm and 4mm. Several types are available 3kg / m2 and 4kg / m2.
The underside is usually Polyethylene (PE) film.
The upper surface finishes can be selected from:
– Polyethylene (PE) film
– Fine sand (S)
– Gray mineral particles (MG)
– Green mineral seeds (MGRN)
– Green mineral seeds (MBL)
– Gray mineral particles (GY)
– Green mineral seeds (GRN)
– White mineral seed (WT)
– Red mineral particles (RD)
Available in rolls of 4kg, 4.5kg and 5kg per square meter. The nominal length of each roll is 10 meters and the nominal width is 1 meter. Special specification can be designed based on customer needs.
The above results are based on 4mm membrane
Tolerances are within 20% of the above results for mechanical properties consistent with the tolerance rating of (ASTM, EN).
Due to continuous product improvement, MODERN Company reserves the right to change the above values without prior notice
HYPERFLEX – P10 films should be stored upright in a sheltered and well ventilated place away from direct sunlight.